The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Brother HL 20/40 Laser Printer Help

    Discussion in 'Accessories' started by paul_r_d, Jan 18, 2009.

  1. paul_r_d

    paul_r_d Notebook Consultant

    Reputations:
    36
    Messages:
    221
    Likes Received:
    0
    Trophy Points:
    30
    My Brother 20/40 mono laser printer has been acting quite strange...... I notice after a number of seperate prints say with in a space of half an hour, it wont allow me to print from the tray. Meaning, the tray is completley full, however it will go to print then the red light flashes "paper"- like there is none. At first I thought my printer had had it, but the next was working fine. It's done this a few times. Not sure if its hardware or software related. Any ideas?
     
    paul_r_d, Jan 18, 2009
    #1
  2. Nocturnal310

    Nocturnal310 Notebook Virtuoso

    Reputations:
    792
    Messages:
    2,708
    Likes Received:
    0
    Trophy Points:
    0
    my brother printer which i sold last year had same problems....it happens because its paper tray belt is located very deep inside and it also gets the paper jammed in it..

    did u open and see it?
     
    Nocturnal310, Jan 18, 2009
    #2