The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Disassembling Zalman 2000 ?

    Discussion in 'Accessories' started by ImYoungxD, Aug 3, 2010.

  1. ImYoungxD

    ImYoungxD Notebook Consultant

    Reputations:
    4
    Messages:
    144
    Likes Received:
    0
    Trophy Points:
    30
    does anyone know how to do it ? all i can do is unscrew the 4 screws and try pulling it apart but no results. im out of warranty and both of the fans work correctly but the right side of the cooler has no breeze through the holes. but the left side seems to get A LOT of air.
     
    ImYoungxD, Aug 3, 2010
    #1
  2. X2P

    X2P COOLING | NBR Super Mod

    Reputations:
    3,179
    Messages:
    5,361
    Likes Received:
    4
    Trophy Points:
    206
    You have to peel off the back two rubber feet (on top) and unscrew both screws then remove the long rubber strip on the front and remove the 5 screws and your in
     
    X2P, Aug 3, 2010
    #2
  3. ImYoungxD

    ImYoungxD Notebook Consultant

    Reputations:
    4
    Messages:
    144
    Likes Received:
    0
    Trophy Points:
    30
    ah i see. i was wondering if i should remove those rubber pads. thanks for the confirmation.
     
    ImYoungxD, Aug 4, 2010
    #3