The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Logitech VX Nano & AutoCAD

    Discussion in 'Accessories' started by ToxicBanana, Sep 18, 2007.

  1. ToxicBanana

    ToxicBanana Notebook Consultant NBR Reviewer

    Reputations:
    19
    Messages:
    170
    Likes Received:
    0
    Trophy Points:
    30
    Does anyone know if the VX nano allows the mouse wheel button to be used for panning in CAD applications (or pan/scroll in any application)?
     
    ToxicBanana, Sep 18, 2007
    #1
  2. DMANbluesfreak

    DMANbluesfreak Notebook Consultant

    Reputations:
    17
    Messages:
    153
    Likes Received:
    0
    Trophy Points:
    30
    I'm not entirely sure about autocad, but in ProEngineer, I have first hand experience that you cannot use it for that.
     
    DMANbluesfreak, Sep 19, 2007
    #2
  3. ToxicBanana

    ToxicBanana Notebook Consultant NBR Reviewer

    Reputations:
    19
    Messages:
    170
    Likes Received:
    0
    Trophy Points:
    30
    I was searching through the forum on Logitech's website, and some people suggest updating setpoint software to version 3.3 or higher, and then setting button 3 to "other" or to "middle button". Another poster suggested that in the Setpoint Software "uncheck - Allow Manual Shifting between modes".

    Have you tried any of these suggestions using ProE?
     
    ToxicBanana, Sep 19, 2007
    #3