The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Looking for a very short and very small stand or table

    Discussion in 'Accessories' started by Peon, Aug 26, 2013.

  1. Peon

    Peon Notebook Virtuoso

    Reputations:
    406
    Messages:
    2,007
    Likes Received:
    128
    Trophy Points:
    81
    I have carpet in my computer room which distorts the sound coming out of my subwoofer, so I'm looking for a stand or table of some sort to raise it a few inches off the ground. Additionally, my sub is roughly 10" wide by 12" long, so the stand/table needs to be tiny.

    For reference, this is the closest I've found so far, but it's still a bit too wide: http://www.monoprice.com/products/product.asp?p_id=9434. On top of that, shipping would cost $40, making it rather expensive in the end.
     
    Peon, Aug 26, 2013
    #1
  2. radji

    radji Farewell, Solenya...

    Reputations:
    3,856
    Messages:
    3,074
    Likes Received:
    2,619
    Trophy Points:
    231
    IKEA, or you can always make one yourself. It's not as hard as it seems. You don't even need all the power tools. That's what I did when I needed a laptop mat for my bed. I got a piece of plywood from Home Depot, they cut it down to size for me. I did the final cut with a router to make the edges even and rounded. Sand, stain, polyurethane. Good to go!
     
    radji, Aug 27, 2013
    #2