The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Modding the CoolerMaster MasterNotepal Pro

    Discussion in 'Accessories' started by darkarn, Aug 20, 2019.

  1. darkarn

    darkarn Notebook Evangelist

    Reputations:
    47
    Messages:
    655
    Likes Received:
    226
    Trophy Points:
    56
    Hi, may I know if it is possible to unscew and remove the bezels below the aluminium plate as shown in the attached picture? I am thinking of placing some rubber pads at each corner of the aluminuim plate instead of using the bezel as I prefer to use it at 0 degrees instead of elevated.

    Thanks!
     

    Attached Files:

    darkarn, Aug 20, 2019
    #1