Hello guys its me again, so after trying everything I got new motherboard pre-tested but i am getting 7 beeps. I checked the processor was getting hot as it should so what could be the problem with my system
Processor??
When i press the powerbutton again once the pc shuts down
-
7 beeps is the CPU or components on the motherboard relating to the CPU. If you’ve just had your board replaced then it’s probably the CPU.
Sent from my iPhone using TapatalkRengsey R. H. Jr. likes this. -
-
Any haswell CPU will work in the Ranger.
Thus far Crystal well has not been successful -
I’ve never seen a 7 beeps issue that turned out to be the CPU, always has been motherboard in my experience
Rengsey R. H. Jr. likes this. -
Rengsey R. H. Jr. I Never Slept
My 17X R4 has 7 beeps and I don’t have a spare cpu to test. It like @Raidriar mentioned, it might be a mobo problem
-
I have had a 17 with a 7 beep issue. It was a faulty 4900. There is hope!
Sent from my iPhone using TapatalkRengsey R. H. Jr. likes this. -
-
-
The 4900MQ or 4910MQ are great CPU's and can be overclocked a little. If you want a fully unlocked CPU grab a 4930MX.
I'm not saying that it isn't another faulty motherboard though so you may just want to get a cheaper 4700 to test -
-
-
Not really. It could still be getting power to it causing it to heat up even if the board is faulty.
-
-
-
If the CPU wasn't seated properly and was clamped down in place then there is a decent chance that it's been damaged. I would remove the CPU and check the pins carefully. Up to you though
-
-
-
-
-
It probably needs an NVRAM reset but I'm not sure how to do that on the 18. If you can find the CMOS battery you can try removing it for a few minutes
-
-
Oh yeah. Sorry, got confused with something else. You need to remove the motherboard to pull the CMOS battery in the 17, stupid design. You can access it through the bottom panel but you have to cut some of the plastic away.
-
8 beeps is an LCD error. Check that the connector is seated properly. Do you have the 3D display? If you do then it's also possible that you have an issue with the GPU as it runs the display
-
-
Was it on Legacy and then you switched to UEFI? You can’t usually do this without formatting your drive and reinstalling windows. I haven’t tried on the 17 though.
Sent from my iPhone using Tapatalk -
-
Do you have the 3D Display?
-
-
The 17 was released with the standard 60Hz Matte display and also the 3D 120Hz Glossy display. The 60Hz display uses Optimus to switch between the Intel and Nvidia graphics. The 3D display MUST use the dedicated Nvidia card so if there is an issue with the GPU then there will be no display and you will get an 8 beep code. It will not revert to the Intel graphics in the event of a dedicated card failure.
-
-
It works just fine in windows installation which is around 10 mins. Everything seems fine in diagnostics of alienware.it works fine in safe modeLast edited: Mar 25, 2020 -
Rengsey R. H. Jr. I Never Slept
got a question. If the laptop is still charging the battery , is the mobo dead with the 7 beep ?
I have a m17x R4 -
Alienware 17 R1 New Motherboard 7 Beeps
Discussion in 'Alienware 17 and M17x' started by Baqir, Mar 24, 2020.