The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    And now?

    Discussion in 'Alienware 17 and M17x' started by raFaeLTx, Apr 29, 2011.

  1. raFaeLTx

    raFaeLTx Notebook Guru

    Reputations:
    7
    Messages:
    61
    Likes Received:
    0
    Trophy Points:
    15
    I thank everyone from the forum now!! ;) ;)
    Thanks also for the great post ... Batboy :)

    http://forum.notebookreview.com/ali...er-install-order-guide-alienware-systems.html

    Tomorrow I get my OCZ Vertex 3 and still with some doubts. For a correct installation of the OS. :eek:

    1 - I need some firmeware for my OCZ Technology 240 GB SATA 3 Vertex III 6.0 Gb / s 2.5-Inch Solid State Drive VTX3-25SAT3-240G?

    2 - compartment which I use 1 or 0 in my r3. for best performance 6gb/s?

    3 - What is the correct bios to use this time? we know to have fewer problems?

    4 - after that I can follow what the Batboy provided us?


    And the last question: the drive 6970m from dell or AMD? which recommends ....

    Thanks for your colaboration..
     
    raFaeLTx, Apr 29, 2011
    #1
  2. raFaeLTx

    raFaeLTx Notebook Guru

    Reputations:
    7
    Messages:
    61
    Likes Received:
    0
    Trophy Points:
    15
    :( this was a bad question?
    my English is not understandable?
    is good or I hit a little? :confused:
     
    raFaeLTx, Apr 30, 2011
    #2
  3. Azureal

    Azureal Notebook Consultant

    Reputations:
    59
    Messages:
    236
    Likes Received:
    0
    Trophy Points:
    30
    Not bad, just very redundant.

    Check out this post: Vertex discussion

    Also, BIOS A03 on R3 is fine.
    Vertex firmware 2.02 is fine.

    Follow directions in ruderthanyou's guide in post listed above.
     
    Azureal, Apr 30, 2011
    #3