The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Bigfoot Wireless Card Steps

    Discussion in 'Alienware 17 and M17x' started by siang_rd, Oct 24, 2011.

  1. siang_rd

    siang_rd Notebook Enthusiast

    Reputations:
    46
    Messages:
    48
    Likes Received:
    0
    Trophy Points:
    15
    Sry guys, just bought a bigfoot wireless card, is anyone out there kind and patient and good enuf to write down what I shud do step by step? Thank you very much. And can some1 pls tell me what shud i disassemble and where is the wirless slot located and anything that i should be aware of? All help is really really really appreciated ! :D
     
  2. Chaos92

    Chaos92 Notebook Consultant

    Reputations:
    138
    Messages:
    272
    Likes Received:
    1
    Trophy Points:
    31
    For the disassembly refer to
    Documentation

    Perphaps watch some videos on youtube..

    Since I ordered with the killer card too, I did some research and found out there is an issue with iTunes. More on that here:

    http://forum.notebookreview.com/alienware-m17x/619360-m17x-itunes-not-happening.html

    http://forum.notebookreview.com/ali...er-wireless-n-1103-incompatibility-issue.html

    http://www.bigfootnetworks.com/Kill...k-Manager-broken-iTunes-(workaround-included)

    Installing the component should be quite easy so don't worry!
     
  3. inap

    inap .........................

    Reputations:
    4,417
    Messages:
    7,827
    Likes Received:
    19
    Trophy Points:
    206
    this is a ram replacement video, but everything is almost the same. the wireless card is in the middle under the keyboard, its the one with 3 leads(black, grey and white). take the old card out and put new one in and install driver.

    http://www.youtube.com/watch?v=rEC1U1WqG5Y