The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    M17x R3 - Razer Naga not working

    Discussion in 'Alienware 17 and M17x' started by Ranaszun, Aug 25, 2012.

  1. Ranaszun

    Ranaszun Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I'm getting an issue with my Razer Naga mouse not working with my M17x R3. It says something like "usb device not recognized" and it won't work. I often have to switch between all of the USB ports to figure out which one it feels like working with. Sometimes if I turn my laptop at all, it will disconnect the mouse again. The mouse works fine with another computer which makes me think that it isn't necessarily the mouse. Anybody run into this issue?
     
    Ranaszun, Aug 25, 2012
    #1
  2. Chris_c81

    Chris_c81 Notebook Consultant

    Reputations:
    125
    Messages:
    245
    Likes Received:
    3
    Trophy Points:
    31
    Is this happening when on battery or mains? Or both?


    Sent from my iPhone using Tapatalk
     
    Chris_c81, Aug 25, 2012
    #2
  3. mx308250

    mx308250 Notebook Guru

    Reputations:
    0
    Messages:
    50
    Likes Received:
    0
    Trophy Points:
    15
    Have you installed Razer Synapse? When mine is plugged into say port 1 and next time I set it up I plug it into port 2 it installs the driver again. It should be automatic, but I always try and use the same USB port.
     
    mx308250, Aug 25, 2012
    #3