The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Command Center problem.

    Discussion in 'Alienware' started by Blazertrek50, Nov 26, 2009.

  1. Blazertrek50

    Blazertrek50 Notebook Evangelist

    Reputations:
    62
    Messages:
    666
    Likes Received:
    114
    Trophy Points:
    56
    You may have already heard of this but I have been unable to use the fusion center for power setups. I had this problem with Vista and now with Win7. I have yet to update the drivers to Win7, do you think that would fix this problem?

    Please comment any of you who have had this problem and managed to fix it.

    Thanks!
     
    Blazertrek50, Nov 26, 2009
    #1
  2. kevblah

    kevblah Notebook Consultant

    Reputations:
    1
    Messages:
    259
    Likes Received:
    0
    Trophy Points:
    30
    i have this problem too, but i dont know the solution to it.
     
    kevblah, Nov 26, 2009
    #2
  3. lgsshedden

    lgsshedden Notebook Consultant

    Reputations:
    16
    Messages:
    299
    Likes Received:
    4
    Trophy Points:
    31
    there were a couple of posts elsewhere on this, so others may post you a solution too: I think its an issue that stems from a registry conflict.
    One solution is to correct this using regedit but a simpler solution is to use administrative tools and services: they are listed alphabetically, check AlienFusion for status and start option and adjust accordingly.
     
    lgsshedden, Nov 26, 2009
    #3