The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    G60J - Alchemy not detects Creative hardware

    Discussion in 'ASUS Gaming Notebook Forum' started by fabe123, Sep 9, 2010.

  1. fabe123

    fabe123 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Hey there,

    I have a G60J (nearly the same like G51J), which should support EAX 4.0 .
    I had installed Realtek 2.51.
    Then I downloaded the Creative Audigy Driver (dont't know what version is this, but it's dated to 2010/08/03) from the Asus support site.
    Now I wanted to install it, but in the setup a messagebox showed up, that no supported hardware was found. Then I installed the Audigy Driver from the Asus driver CD (I hadn't installed it before, because it's a fresh system), which worked. After that I could install the driver of the Asus site too.

    Now the problem: With both driver versions I couldn't launch Creative Alchemy, because it showed up, there no supported device.....

    I also tried it with the new Realtek 2.52 version.
     
    fabe123, Sep 9, 2010
    #1