The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    G73jh and Chinese FirePro m6000 warning

    Discussion in 'ASUS Gaming Notebook Forum' started by Echoa, Sep 21, 2017.

  1. Echoa

    Echoa Notebook Enthusiast

    Reputations:
    2
    Messages:
    19
    Likes Received:
    5
    Trophy Points:
    6
    Just wanted to give a friendly warning to those who might be looking to upgrade their g73jh to a Firepro m6000/7870m you should steer clear of listings that say things like " For ASUS G73JH ATI 5870M 1GB upgrade 7800M M6000 2GB video card Plug and Play"

    These cards do work but with a catch, they are modified

    [​IMG]

    In a poor bit of decision making they pull off one of the Inductors and replace it with a smaller and weaker one with the logic of "It makes the heatsink fit better" (that's what they told me, and tbh the heatsink should fit fine without this). While the card will continue to work fine for light loads and general use, if you put it under a stressful/high current draw load like a maxed out Heaven benchmark @ 1080p your card will cause the system to just shut off.

    If you're curious though these are Dell FirePro m6000 cards, if you come across a chinese seller with unmodified cards you should be fine but ones specifically listed for the g73jh seem to have this modification.
     
    Last edited: Sep 21, 2017
    omn and Arrrrbol like this.
  2. Arrrrbol

    Arrrrbol Notebook Deity

    Reputations:
    3,235
    Messages:
    707
    Likes Received:
    1,054
    Trophy Points:
    156
    Good to know. Its always hit or miss when you buy from a Chinese seller. If its only that component which was replaced though, you could try to solder an original inductor back on, as long as you can find one for sale.
     
  3. Echoa

    Echoa Notebook Enthusiast

    Reputations:
    2
    Messages:
    19
    Likes Received:
    5
    Trophy Points:
    6
    I don't have equipment or a place near by to do it for me. I just returned it and ordered one from another seller along with a couple shims because the die is lower than the 5870. Someone with more experience soldering and the equipment to do so definitely.
     
    Arrrrbol likes this.