The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    A little water got on my v1jp

    Discussion in 'Asus' started by Ev0lutionz, May 13, 2008.

  1. Ev0lutionz

    Ev0lutionz Notebook Consultant

    Reputations:
    0
    Messages:
    111
    Likes Received:
    0
    Trophy Points:
    30
    Was cycling, raining at that time.. Was cycling pretty fast, 30 odd km/h. So when i reached a puddle, the water splashed on my bag. Somehow water seeped through. Still working fine now. But i think it hasnt touched the internal circuitry yet. Only touched the back where the battery is. So how long should i turn it on until its safe?
     
  2. RandomX

    RandomX Notebook Enthusiast

    Reputations:
    0
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    5
    take to it with a hair dryer and hope the water had no contaminants, otherwise that internal circuitry is done for....
     
  3. Dreidel

    Dreidel Notebook Evangelist

    Reputations:
    144
    Messages:
    315
    Likes Received:
    0
    Trophy Points:
    30
    maybe if u tell us what kind of bike you ride we can better answer your question
     
  4. Ev0lutionz

    Ev0lutionz Notebook Consultant

    Reputations:
    0
    Messages:
    111
    Likes Received:
    0
    Trophy Points:
    30
    Btw does the kesington lock port run on electricity? It went inside there.
     
  5. E.B.E.

    E.B.E. NBR Procrastinator

    Reputations:
    1,572
    Messages:
    8,632
    Likes Received:
    4
    Trophy Points:
    206
    Huh?

    Nope, it is just a hole. but depending on the notebook that hole may lead to internals without separation.

    I would suggest you take the affected area apart as much as you can (i.e. into as many basic components as you can) and let it dry for a day or two. ASAP. :)