The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Asus laptop ROG G53sx FAN constantly running at max speed

    Discussion in 'Asus' started by ttengg, Dec 25, 2015.

  1. ttengg

    ttengg Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Asus laptop ROG G53sx FAN constantly running at max speed both CPU and GPU fan

    it happen after i clean my heat fins using vacuum cleaner
    the CPU and GPU temp is under 40c so its not over heating

    what i tried

    download speed fan , no luck it wont let me set the fan speed using program
    re flash the bios using CMD /nodate
    remove Cmos battery ,laptop battery press power button 30 sec , still no luck


    any suggestions/solutions?


    Thanks in advance
     
    ttengg, Dec 25, 2015
    #1
  2. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,431
    Messages:
    58,192
    Likes Received:
    17,900
    Trophy Points:
    931
    It's possible static from the vacuum cleaner has damaged the fan monitoring, check the fan cables are in properly.
     
    Meaker@Sager, Dec 26, 2015
    #2
  3. ttengg

    ttengg Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    thanks for reply cable looks good to me , laptop have 2 fan gpu and proci , already tried switching them same result
     
    ttengg, Dec 26, 2015
    #3
  4. ttengg

    ttengg Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    problem solve! i apply new thermal compound then magic works
     
    ttengg, Dec 28, 2015
    #4