The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    N56VZ - What does your LCD bezel/frame look like?

    Discussion in 'Asus' started by matthewr87, Sep 4, 2012.

  1. matthewr87

    matthewr87 Notebook Enthusiast

    Reputations:
    0
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    5
    Hello everyone,

    Bought my N56VZ-DS71 last Friday and am trying to decide whether to exchange it. Perhaps the biggest issue it has is that the LCD frame is loose in places and makes squeaking noises when pressed against the lid. In addition, when I first received it I noticed that the top left hand corner was separated by about 5 or 6 mm. The screw holding the actual LCD in place was not seated properly so I tightened it. The gap is still not quite as tight as on the right side but significantly better than before. Also, I get an annoying cracking noise every time I open the laptop because I invariably press on the bezel when holding the lid. Is this a common problem? The build quality seems poor on mine.
     
    matthewr87, Sep 4, 2012
    #1