The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    UX31e keyboard upgrade to UX31a keyboard - Possible?

    Discussion in 'Asus' started by Spect7, Oct 30, 2013.

  1. Spect7

    Spect7 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hi everyone, My first post here.

    I have been searching around for information on upgrading my keyboard and I found this thread. Unfortunately its gone dead and there isn't much information though. http://forum.notebookreview.com/har...ding-asus-ux31e-keyboard-backlight-ux31a.html

    Can anyone tell me for certain if the UX31a keyboard will work on my older UX31e? I don't care about the backlit buttons or anything, I just want a better feeling keyboard. My stock one has always been really poor and I get strain in my fingers from using it.

    Cheers, :)
     
  2. Spect7

    Spect7 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    ---Tumbleweed------
     
  3. harrypotato

    harrypotato Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    I'm after the same information, it will be really helpful if someone out there can provide an answer :)
     
  4. xenor_

    xenor_ Newbie

    Reputations:
    0
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    5
    old post but i replaced my keyboard and it's way better than the old one. just the backlight isn't working. it has the same pins as the old keyboard and i think it's a controller problem.
    you should take some time to change the keyboard and be ready to remove a lot of 0.9mm screws ;)

    if anyone has any idea how to make the backlight work please tell me! maybe by replacing the webcam to the 31a one with the ambient light sensor?