The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Z70va Frame around screen lose

    Discussion in 'Asus' started by Dmayner, Feb 28, 2006.

  1. Dmayner

    Dmayner Notebook Geek

    Reputations:
    0
    Messages:
    86
    Likes Received:
    0
    Trophy Points:
    15
    Greetings All,

    I hope that I can explain this in a way that everyone can understand. I recently noticed that the plastic frame around the screen of my Z70va does not fit tightly against the screen on the lower right half of the screen. Everywhere else around the screen it fights properly. It is like the plastic is slightly warped or whatever is used to hold it in place didn't work properly. So, I guess my questions is, do I need to worry about this or is there anything that can be done to fix it? Thanks.

    Dave
     
    Dmayner, Feb 28, 2006
    #1
  2. coriolis

    coriolis Notebook Nobel Laureate

    Reputations:
    2,319
    Messages:
    14,119
    Likes Received:
    1
    Trophy Points:
    455
    It could be a loose screw inside, I would check with your dealer to get it fixed.
     
    coriolis, Feb 28, 2006
    #2
  3. AuroraS

    AuroraS Notebook Virtuoso

    Reputations:
    651
    Messages:
    3,497
    Likes Received:
    0
    Trophy Points:
    105
    Try removing the rubber stopper on the bottom right: there should be a screw behind it. If it's loose, tighten it, and all should be well.
     
    AuroraS, Feb 28, 2006
    #3