The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Do I need to setup 1.x?

    Discussion in 'e-GPU (External Graphics) Discussion' started by Half Fuman Chew, May 29, 2012.

  1. Half Fuman Chew

    Half Fuman Chew Newbie

    Reputations:
    0
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    5
    Hi,

    I am configuring a pe4h+Pm3n on my laptop through my mpcie that my wireless card was plugged into. I am having an issue starting windows with the egpu connected, both the psu and gpu fans power on when I switch the atx psu on but my computer won't resume from standby or boot, it just lights up and the off and then back on again etc. so I was wondering if I need to setup 1.x or if it a different issue? My laptop is an acer aspire 5745g i7 720qm with just a nvidia gpu and I want to use a gtx550 to egpu on it.

    Cheers
     
    Half Fuman Chew, May 29, 2012
    #1