The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    External Monitor runs, but hangs at HP logo

    Discussion in 'e-GPU (External Graphics) Discussion' started by kimern_8, Jul 16, 2012.

  1. kimern_8

    kimern_8 Notebook Enthusiast

    Reputations:
    0
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    5
    So after x amount of hours, i finally have some results. After powering off my laptop, powering it on and plugging in my egpu, the external monitor powers on and i can see the HP logo, but that is as far as i get. Does Anyone have any experience with this? What i did was simply updating the BIOS and turning the virtualization technology off. But as i said, that is pretty much as far as i have gotten. After searching for hours in the forum i still haven't got any answers.

    I have a HP Elitebook 2540p
    Core i5 2.53GHz
    4GB ram
    Windows 7 Enterprice 64-bit

    Anyone have some ideas?

    (Oh! and im running a AMD Radion 4800 series with a 600W psu)
     
    kimern_8, Jul 16, 2012
    #1
  2. kimern_8

    kimern_8 Notebook Enthusiast

    Reputations:
    0
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    5
    Incase anyone has seen this post and has the same problem i descrived above, i found a fix for it.
    I simply tried another graphic card (gtx 680)
    So there you have it :)
     
    kimern_8, Jul 17, 2012
    #2