The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    PE4H+PM3N mPCIe card

    Discussion in 'e-GPU (External Graphics) Discussion' started by Half Fuman Chew, May 28, 2012.

  1. Half Fuman Chew

    Half Fuman Chew Newbie

    Reputations:
    0
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    5
    Hi All,

    I just recieved my PE4H v2.4a + PM3N adapter and the PM3N card it is really long. I was wondeirng if i could cut the end of the card off just after the first set of screw holes, or is that part of the adapter required for the circuit?

    I only ask as it would fit better in my laptop.

    Cheers,
    Tim
     
    Half Fuman Chew, May 28, 2012
    #1
  2. SimoxTav

    SimoxTav Notebook Evangelist

    Reputations:
    273
    Messages:
    442
    Likes Received:
    0
    Trophy Points:
    30
    Yes you can, the card comes with 2 sets of holes to fit both half size mPCIe slots and full size one :)

    Feel free to cut the PCB after the half length holes with no worries :)
     
    SimoxTav, May 29, 2012
    #2
  3. droidarmy95

    droidarmy95 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    may I ask how do you cut it?
     
    droidarmy95, Jul 7, 2012
    #3