The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    n6010 memory upgrade

    Discussion in 'Fujitsu' started by stjepanovic, Jul 26, 2007.

  1. stjepanovic

    stjepanovic Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    I have upgraded memory to 1.5 gig but the sytem did not recognize the complete 1.5 gig of RAM (only 1024MB). Than I have changed the memory module and although BIOS and SYS recognized 1.5 gig Check-it test reported a problem with the memory. Later I added an aditional 1gig (2 gig 2x1gig) and that did not work eihter. Is anyone aware of conflict problems or is it possible that there is faulty memory slot on N6010. What should I do? I ran TestMem86 for each module seprately and they ran fine. I used correct ECC DDR(333) SODIM 200 pin Ram. Any clues suggestions? The old combo (2x512) Swissbit modules are fine too. Desperate.

    Never buy Fujitsu
     
    stjepanovic, Jul 26, 2007
    #1