The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Advice-basic autocad/3d modelling-HD3650

    Discussion in 'Gaming (Software and Graphics Cards)' started by saxman, Aug 27, 2008.

  1. saxman

    saxman Notebook Enthusiast

    Reputations:
    0
    Messages:
    29
    Likes Received:
    0
    Trophy Points:
    5
    Would really like to choose the T500 over the T61p based on its switchable graphics and other options- can any cad users advise if the HD3650 in the T500 can work well enough as opposed to going to the Quadro in the T61p or the W500?
     
    saxman, Aug 27, 2008
    #1
  2. Thaenatos

    Thaenatos Zero Cool

    Reputations:
    1,581
    Messages:
    5,346
    Likes Received:
    126
    Trophy Points:
    231
    I never had good luck with ATi and Cad here at work. But then again the last time I tried was in the x1XXX series.
     
    Thaenatos, Aug 27, 2008
    #2