The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    m17x r3, 580m, Optimus and Flight Simulator X

    Discussion in 'Gaming (Software and Graphics Cards)' started by Gerry47, Oct 4, 2011.

  1. Gerry47

    Gerry47 Notebook Geek

    Reputations:
    0
    Messages:
    86
    Likes Received:
    0
    Trophy Points:
    15
    Hi
    I asked this question on the m17x forum and got some good advice about using new nVidia drivers but maybe someone here has had the same problem and can give some added advice please?

    I have my m17x r3 for one week and have been trying to get FSX to run properly since then. In the nVidia control panel FSX is listed as a programme and set to use the nVidia processor.

    When I go to the "Settings" tab in FSX, under "Device" it says "Intel (R) HD Graphics Family .0.0" and does not list the 580m. In game I am getting between 10 and 50+fps with settings on high to max. (I also have the sim on my m11x r1 and that lists the graphics card under the same tab).

    The sim runs quite well but often when I exit I get a "fatal error" message and the sim re-starts itself. Also when I launch the game sometimes the window that should display the aircraft under the "free flight" tab is black but sometimes you can see the aircraft that is being loaded.

    A noob question but is the graphics card running the game or is it the gpu on the processor? Has anyone had a similar problem? Any suggestions or solutions please?

    Alienware m17xr3 (non-3d)
    Core i7 2860QM
    8Gb RAM
    750 Gb

    Thanks for your help.

    Gerry
     
    Gerry47, Oct 4, 2011
    #1