The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    9c.12.00 won't install?

    Discussion in 'Gateway and eMachines' started by RangerXML, Jun 9, 2009.

  1. RangerXML

    RangerXML Army of None [TRH]

    Reputations:
    211
    Messages:
    1,437
    Likes Received:
    0
    Trophy Points:
    55
    I went to both e-wreck posts looking for something I may have missed. I remember 9c.10.00 was just a unzip, run as admin and run deal. For some reason I keep getting an error when I try and flash to 9c.12.00

    The error:

    Drive(WDM) Init fail!(0x137)

    It might have something to do with Vista 64 SP2 and that it was written for SP1?
     
    RangerXML, Jun 9, 2009
    #1