The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Gateway 400SD4/Motherboard crack

    Discussion in 'Gateway and eMachines' started by bobbymia, Nov 16, 2004.

  1. bobbymia

    bobbymia Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    I have had my Gateway 400SD4 lap-top for less than 2yrs. i was having trouble with my AC power cord. It was plugged into the back of the notebook, but did not seem to be charging anymore. I took my Lap-Top apart and noticed that a tiny piece of the motherboard (where the power cord connector tip would meet) has broke off. Has anyone else ever encountered this problem? Does it look like I will have to purchase The entire motherboard for this tiny piece. I am hoping for another alternative....I would appreciate any suggestions...thankx, BM
     
  2. jmackey

    jmackey Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I have the same problem you were having on your Gateway laptop with a similiar model. Mine also is not yet 2 yrs old and is out of warranty. Have you found a resolution to the problem short of replacing the motherboard?
     
  3. bobbymia

    bobbymia Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
     
  4. rasheed_61615

    rasheed_61615 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I just had that problem. Go to ebay and look up Gateway 400sd4 dc jack. You can buy one for like 6 bucks. take the motherboard to a local electronics shop and have them solder the new piece on. That might save you abot 300$.