The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    I've been a bad, bad boy

    Discussion in 'Gateway and eMachines' started by TANWare, Feb 18, 2012.

  1. TANWare

    TANWare Just This Side of Senile, I think. Super Moderator

    Reputations:
    2,548
    Messages:
    9,585
    Likes Received:
    4,997
    Trophy Points:
    431
    I upgraded the cooling system back in August of 11. Well I've been a bit neglectfull! I haven't used compressed iar since that time.

    Just installed Realflight again, new version, and temps were running well over 85c.Ran to Target and after a few good puffs to the system and cooling pad now I see 70c from the GPU................
     
  2. psyauto

    psyauto Notebook Guru

    Reputations:
    20
    Messages:
    62
    Likes Received:
    2
    Trophy Points:
    16
  3. TANWare

    TANWare Just This Side of Senile, I think. Super Moderator

    Reputations:
    2,548
    Messages:
    9,585
    Likes Received:
    4,997
    Trophy Points:
    431
    Wow, nice job. Actually my added small HS on the CPU pipe slighly protruses so I can't go that route. Again though, nice job!
     
  4. brandon1186

    brandon1186 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    hey tan can i talk to you about overclocking my q9000
     
  5. TANWare

    TANWare Just This Side of Senile, I think. Super Moderator

    Reputations:
    2,548
    Messages:
    9,585
    Likes Received:
    4,997
    Trophy Points:
    431
    Like the non extreme vesrions of C2D you can not really overclock the q9000except by FSB but then you will have to hard mos the main board..................