The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    P-6860fx Cpu Screws!

    Discussion in 'Gateway and eMachines' started by XxDizzyxX, Mar 18, 2010.

  1. XxDizzyxX

    XxDizzyxX Notebook Enthusiast

    Reputations:
    0
    Messages:
    25
    Likes Received:
    0
    Trophy Points:
    5
    Hello,

    I've recently got a new CPU for my P-6860fx laptop. When I was disassembling
    it I've accidently striped the top of one of the screws that holds down the CPU
    heat sync. Where can I get a hold of one of these screws?

    I've contacted Gateway and they say its out of warranty and won't assist me
    with the problem.
     
    XxDizzyxX, Mar 18, 2010
    #1
  2. Evil Claw

    Evil Claw Notebook Evangelist

    Reputations:
    7
    Messages:
    386
    Likes Received:
    0
    Trophy Points:
    30
    Take the screw with you to Radio Shack or some electronics store in your area. You should be able to find its replacement there. Good luck.
     
    Evil Claw, Mar 19, 2010
    #2
  3. WysockiSauce

    WysockiSauce Notebook Consultant

    Reputations:
    67
    Messages:
    276
    Likes Received:
    0
    Trophy Points:
    30
    I did the same thing, I've been using one of the screws from the wifi card. It's a bit shorter but it does the trick ;D
     
    WysockiSauce, Mar 20, 2010
    #3
  4. xxERIKxx

    xxERIKxx Notebook Deity

    Reputations:
    159
    Messages:
    1,488
    Likes Received:
    0
    Trophy Points:
    55
    i only have two screws holding my cpu heatsink... my temps are fine though.
     
    xxERIKxx, Mar 20, 2010
    #4