The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Questions about RAID 0 and partitioning

    Discussion in 'Gateway and eMachines' started by flclkun, May 6, 2009.

  1. flclkun

    flclkun Notebook Enthusiast

    Reputations:
    0
    Messages:
    43
    Likes Received:
    0
    Trophy Points:
    15
    I recently setup my pc in a raid 0 configuration, afterward i created a separate partition, which vista recognizes in My Computer. Now im facing a problem when trying to install windows 7 for dual booting. During installation and pointing were i wish to install windows ( which would be the new partition that i created) it does not display both my partitions.

    Im i doing something wrong? Is it a hardware issue? or a software issue?


    Has any currently have their pc setup in a RAID 0 configuration and are dual booting?

    EDIT: nvm my install was just being stupid.
     
    flclkun, May 6, 2009
    #1
  2. sparkyman2000

    sparkyman2000 Notebook Consultant

    Reputations:
    29
    Messages:
    269
    Likes Received:
    0
    Trophy Points:
    30
    Grats on the stupid installer. Now im sorta quad booting with windows 7 xpm.
     
    sparkyman2000, May 6, 2009
    #2