The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    mx7515 stanby option lost

    Discussion in 'Gateway and eMachines' started by philipC, Feb 20, 2007.

  1. philipC

    philipC Newbie

    Reputations:
    0
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    5
    Hello all, Couple of weeks back, i changed and saved the display setting on my MX7515[Omega driver 3.8.330] to watch a movie. The laptop was connected to a TV. After that the standby options disappeared. It does not hibernate or standby anymore. I can turn off the monitor & harddrive but it never goes into standby mode. Even when i close the lid of the laptop it does nothing and there are no options for it in the power schemes.
    Also initially i had to press Fn+F4 to change display to TV, but now it does not work, i have to go through the properties setting on the laptop to change the display mode. I have removed and reinstalled the VGA drivers but still no luck. Any suggestions?
    Thanks
    Philip
     
    philipC, Feb 20, 2007
    #1