***Aorus X7 Pro owner's lounge***

1. Clean everything off with IPA
2. Clamp the 2 heatsinks together i used MX2 between them and bond with epoxy , Make sure everything lines up 100% with all screw holes otherwise you will need to start over !( the steal epoxy will be better i think but this works for now )
3. Replace all the heat pads i bought 1MM and 0.5MM ( i only used the 1MM )
4. Apply thermal paste i used MX2 but will maybe try GELID EXTREME next some time
5. Put everything back together and run a good few tests after about 2 hours everything should settle and temps should stabilize <3

 

i hope this helps some people if they have this unit like me ..

i restore Clevo laptops and thought let me take a chance on this one i have learnt loads thank you AORUS X7 PRO


PS: Temps on the CPU are a solid 8 degrees down and both GPU's are around 10 degrees down on each

 

My CLEVO P370EM V.S. GIGABYTE X7V3

https://www.3dmark.com/compare/fs/12378252/fs/15397788#

 

Good morning all ... Can anyone confirm if the 2 GPU's have same VBios or like mine in the image?

 

Looks like two different vbois versions to me, the question is was this done on purpose by the vendor or not.

 

I think it was ... but I can only speculate this .

I can not seem to find anything on them on the net

 

I would agree as it would make sense to regulate the power/heat to meet the cooling solution requirements.

Hopefully some other pro owners will share and shine some light soon.