The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Can you undervolt the lowest multiplier?

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by rudyzhou2, Jan 3, 2009.

  1. rudyzhou2

    rudyzhou2 Notebook Enthusiast

    Reputations:
    0
    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    5
    If yes, how by using RMClock? I cant get the stress test to run at the lowest multiplier possible...
     
    rudyzhou2, Jan 3, 2009
    #1
  2. Kamin_Majere

    Kamin_Majere =][= Ordo Hereticus

    Reputations:
    1,522
    Messages:
    2,680
    Likes Received:
    0
    Trophy Points:
    55
    Each CPU will be different, you might not be able to undervolt your low multiplier. I was able to get all of mine undervolted, but i also got lower than most everyone else i've seen with x9000's

    So your CPU might just not accept an undervolt at the lowest multiplier it has.
     
    Kamin_Majere, Jan 3, 2009
    #2
  3. sgogeta4

    sgogeta4 Notebook Nobel Laureate

    Reputations:
    2,389
    Messages:
    10,552
    Likes Received:
    7
    Trophy Points:
    456
    Follow the RMClock guide... You should be able to disable all the higher multipliers...
     
    sgogeta4, Jan 3, 2009
    #3