The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    E-machines E625 reassembly

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by erasmus666, Sep 2, 2013.

  1. erasmus666

    erasmus666 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    I would appreciate help with the following:

    I have an E-machines E625 laptop. I followed a video how to dissemble the machine as I needed to replace the connection where the mains lead enters the body. Unfortunately, I forgot to make notes as I went along about what goes where so that when I tried to put it all back together again I'd know what to do but I didn't!!! Entirely my own fault!! Does anyone have a link or document how to reassemble the machine PLEASE? I've contacted E-machines who refused pointblank to help so I hope you can oblige.

    Many thanks in advance.
     
    erasmus666, Sep 2, 2013
    #1
  2. tilleroftheearth

    tilleroftheearth Wisdom listens quietly...

    Reputations:
    5,398
    Messages:
    12,692
    Likes Received:
    2,717
    Trophy Points:
    631
    The easiest way is to go through the video again and make notes this time.

    With the last notes first, of course, and opposite of what the disassembly video describes (eg. install 3 screws instead of 'remove three screws') - so you can get you machine together.

    Good luck.
     
    tilleroftheearth, Sep 2, 2013
    #2