The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    HP DM3z overheating... fans not turning on

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by TSE, Aug 13, 2011.

  1. TSE

    TSE Notebook Deity

    Reputations:
    235
    Messages:
    889
    Likes Received:
    21
    Trophy Points:
    31
    So I don't know what's wrong with this computer.

    It has an AMD Neo Dual Core processor and AMD Radeon 3200 HD Graphics.

    I did a clean reinstall with all the original restore discs and got rid of all the HP Bloatware crap like usual and gave it to my brother... however, the fans never turn on.

    Playing League of Legends it overheats then shuts off by itself. I tried installing Speedfan and manually setting the fans higher, but that does nothing.

    I ran Windows update and updated to the latest catalyst drivers also.

    Even running basic internet it gets SUPER hot...
     
    TSE, Aug 13, 2011
    #1
  2. funky monk

    funky monk Notebook Deity

    Reputations:
    233
    Messages:
    1,485
    Likes Received:
    1
    Trophy Points:
    55
    Make sure the fan is plugged in properly, sometimes the connector can mess up a little.
     
    funky monk, Aug 13, 2011
    #2
  3. Bog

    Bog Losing it...

    Reputations:
    4,018
    Messages:
    6,046
    Likes Received:
    7
    Trophy Points:
    206
    Have you cleaned the inside of the computer for dust and other debris?
     
    Bog, Aug 14, 2011
    #3
  4. TSE

    TSE Notebook Deity

    Reputations:
    235
    Messages:
    889
    Likes Received:
    21
    Trophy Points:
    31
    I will tear it apart and see the connection and clean it out.

    I did this about 5 months ago, but I will do it again. Thanks for the help thus far.
     
    TSE, Aug 14, 2011
    #4
  5. funky monk

    funky monk Notebook Deity

    Reputations:
    233
    Messages:
    1,485
    Likes Received:
    1
    Trophy Points:
    55
    If you end up pulling out the fan to check the connection, while you're at it you may as well hook it up to a battery pack or something to make sure it actually works. The bearing could be shot or something.

    Provided you use less than or equal the voltage it says on the fan you won't run the risk of frying it. They can usually take like 1.5-2 times the voltage they're rated at though but that will reduce the lifespan hugely or just blow the whole thing if you push it too far.
     
    funky monk, Aug 15, 2011
    #5