The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Having problems with SRS6

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by Sergy, Jun 23, 2014.

  1. Sergy

    Sergy Notebook Enthusiast

    Reputations:
    24
    Messages:
    11
    Likes Received:
    4
    Trophy Points:
    6
    Edit: I'm so sorry for posting this on the wrong section, It would be nice if you could move it to the right one.

    Hello everyone,
    Recently I wipe all my laptop information to make a fresh Windows 8.1 installation on my Samsung NP350V4C.

    I've followed some instructions found here to create a recovery partition with SRS 6 and the process was a success.

    The recovery partition I've created was empty since I don't have the original back up files.

    My intention was to use the function "Initial Back Up, save the current status of drive C as an initial back up" when Windows 8.1, Office and Samsung software installation was complete to fill that recovery partition, but when I try to install the software this message prompts (see attachment)

    I'm using the same Admin Tools for SRS6 that I used to create the partition, so I don't know what to do, I'd appreciate any help you can give to me.



    Sent from my RM-915_lta_brazil_211 using Tapatalk
     

    Attached Files:

    Sergy, Jun 23, 2014
    #1