The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    How to properly dillute the Arctic Alumina Thermal Adhesive?

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by Loney111111, May 4, 2013.

  1. Loney111111

    Loney111111 Notebook Deity

    Reputations:
    396
    Messages:
    828
    Likes Received:
    28
    Trophy Points:
    41
    I came across this thread on Overclock.net when I was doing some research on how to install RAM heatsinks onto my laptop's VRAMs.

    Quoted from the OP:

     
    Loney111111, May 4, 2013
    #1
  2. ellalan

    ellalan Notebook Deity

    Reputations:
    336
    Messages:
    1,262
    Likes Received:
    82
    Trophy Points:
    66
    I wouldn't do that on a laptop as they are mobile devices and the chances of heat sink falling off and damage the motherboard are high.
     
    ellalan, May 5, 2013
    #2