The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Lenonvo T410 battery problem

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by TheFox1, Sep 24, 2015.

  1. TheFox1

    TheFox1 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Hi,

    Hi have a T410 with a 70++. Since a couples of days it will not charge.
    I plugged the battery in the T420 I have and the battery charges fine.

    The Lenovo Power Manager says I'm using anywhere from 135watts to 2 million watts. When I turn off the computer and unplug it, the green plugged in light stays on.

    I reinstalled the lenovo power manager and power driver also the windows driver, same problem.

    I have to remove the battery and put it back in again so that it will go off. When the laptop is turned off it does not charge either. I figure it's a motherboard issue. Any ideas? If it's a board issue, does anyone know what type of part needs to be replaced (my uncle can weld anything, but needs to know where the problem is)
     
  2. tilleroftheearth

    tilleroftheearth Wisdom listens quietly...

    Reputations:
    5,398
    Messages:
    12,692
    Likes Received:
    2,717
    Trophy Points:
    631
    I don't think a welder can help here.

    Unless you want to spend more than the notebook is worth, I suggest taking it for an estimate to a Lenovo service center.

    But for an almost 5 year old notebook, it may be better to simply start looking for a new one instead of repairing this one.

    See:
    http://www.amazon.com/Lenovo-ThinkPad-20DF002YUS-15-6-Inch-Laptop/dp/B00SCAYW2M


    Similar (raw) performance to what you have now, for only ~$400.

    Good luck.
     
  3. TheFox1

    TheFox1 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Replaced the jumper for the back light on a t420 screen for 45$. If I know where to look, it will be cheaper ;)
     
  4. t456

    t456 1977-09-05, 12:56:00 UTC

    Reputations:
    1,959
    Messages:
    2,588
    Likes Received:
    2,048
    Trophy Points:
    181
    Swap the adapters and retry. Every battery needs a minimum 'kick-off' voltage and the T410 adapter could be failing to deliver that. If this didn't make a difference, then you need to re-solder the battery connector or apply some contact cleaner on the pins, whichever works.

    Hm ... does the T420 battery charge in the T410?
    :confused: :D
     
    tilleroftheearth likes this.
  5. TheFox1

    TheFox1 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Good Idea, I'll try the power adapter from the T420 tonight. I did notice that when I unplug the power adapter, on battery, the power manager says 20-25 watts.
     
  6. TheFox1

    TheFox1 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Just gave it a try with the T420 power adapter and it does not work. Removed the battery and left the power adapter in and the wattage still fluctuates between 100-180watts. The power adapter that comes with these notebooks is 65watts which is more than ample as the laptop normally consumes 8-30 watts. I know the battery won't charge if it detects that the power adapter has insufficient wattage to power the laptop. Is there some sort of logic chip that reads a wattage output?
     
  7. t456

    t456 1977-09-05, 12:56:00 UTC

    Reputations:
    1,959
    Messages:
    2,588
    Likes Received:
    2,048
    Trophy Points:
    181
    The other adapter read 2MW, right? So the battery is fine, but there's something amiss with the T410. Try a kill-a-watt or the like, something that will show power fluctuations from the socket. Some its large capacitors may have failed, check for signs of that. Old type, though, more likely you have mainly film capacitors (on the left).

    Other than that, a component may be shorting. Remove as much as possible, while still having a booting system. Live usb is fine, just as long as you can check power draw. Try if it'll boot without display; backlight is high voltage.
     
  8. ajkula66

    ajkula66 Courage and Consequence

    Reputations:
    3,018
    Messages:
    3,198
    Likes Received:
    2,318
    Trophy Points:
    231
    To me it sounds like the fuse that controls the charging process has been blown.

    If you can open up the machine and check those *really tiny* fuses with a multimer, you should be able to locate the culprit since it will be the only fuse with an "open" reading.

    Good luck.