The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.
← Previous page

    Need help for PM/GM965 FSB downclock

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by donluca, Sep 7, 2020.

  1. donluca

    donluca Notebook Enthusiast

    Reputations:
    0
    Messages:
    27
    Likes Received:
    0
    Trophy Points:
    5
    It's interesting, I've managed to get the FSB *almost* up to 1066Mhz, got it to something like 1034Mhz and then the notebook would just reboot.

    There's no middle ground, it's either put half a Mhz above that and it will reboot, keep it below and it's perfectly stable even under stress.

    Go figure.
     
    donluca, Oct 7, 2020
    #51
  2. remdale

    remdale Notebook Evangelist

    Reputations:
    41
    Messages:
    489
    Likes Received:
    181
    Trophy Points:
    56
    RAM overclock + integrated video core overclock without raising their voltage. One of them fails here I assume.
    I'm curious if the BSEL mod will work out or not.
     
    remdale, Oct 7, 2020
    #52
← Previous page