The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Screen Shorting Out--Suggestions??

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by raydanator, Jun 13, 2008.

  1. raydanator

    raydanator Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Long story short, I just got a used Dell C800 notebook, and though it was said to be working fine, the screen shorts out.

    Meaning usually the backlight will not be on, the screen will flicker on and off depending on how you hold it, or the screen is just black.

    The screen also bends back and incredibly long ways...at least parallel with the keyboard...which I don't believe to be normal either.

    I won't be able to have it looked at for a month at least, and am wondering if this is a common issue that me and my techy cousin can easily fix?

    --I'm thinking a connection is loose, but I really have no idea. Any ideas on the problem?? Thanks
     
  2. K-TRON

    K-TRON Hi, I'm Jimmy Diesel ^_^

    Reputations:
    4,412
    Messages:
    8,077
    Likes Received:
    2
    Trophy Points:
    205
    Okay, it seems like their is a connection issue. This issue is arising because of loose hinges. When the screen is tilted all of the way back, the wires are going to be pulled more than they have to be, thus causing the connections to come disconnected.
    The simplest thing to do, is remove the plastic bezel which covers the hinges. Use a small flathead screwdriver to prop the bezel off. Then use a pair of pliers and screwdriver/wrench to tighten the laptop hinges. Do this in small increments, cause you may overtighten one side or both sides.
    Then take the plastic housing off of the monitor. (The screws are under the small rubber circles) Then reconnect the inverter and lcd cables. Then when they are all reconnected, use some tape to hold the wires in place. (so that if the screen silts back too far, they do not become disconnected)
    Then reassemble the laptop and start it up.

    I hope this helps

    K-TRON