The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Screw sizes for Sony VGN S2VP laptop

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by vfclists, May 23, 2008.

  1. vfclists

    vfclists Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    What screw sizes are needed to close up a Sony VGN S2VP?

    I opened up the case some time back and misplaced the screws?

    Are they standard size screws which can be obtained from the a specialist hardware shop?
     
    vfclists, May 23, 2008
    #1
  2. K-TRON

    K-TRON Hi, I'm Jimmy Diesel ^_^

    Reputations:
    4,412
    Messages:
    8,077
    Likes Received:
    2
    Trophy Points:
    205
    that is certainly not good. You better go look for the screws. The screws are going to be different sizes and lengths for the different holes in the laptop. I am sure that you remember taking out different size and length screws. Your best bet is to go look for them, cause you are going to have lots of guess and check work if you cannot find them.

    Wouldnt it be great if notebooks made use of a universal length and width screws.

    K-TRON
     
    K-TRON, May 23, 2008
    #2