The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Using throttlestop for 3rd gen intel CPU i7-3****?

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by SJLPHI, Dec 27, 2021.

  1. SJLPHI

    SJLPHI Notebook Evangelist

    Reputations:
    12
    Messages:
    408
    Likes Received:
    59
    Trophy Points:
    41
    Hello, there are a lot of contradicting information floating around on the internet. One of them is on undervolting and throttlestop.

    I have been using Intel XTU to undervolt my 7th gen CPUs for a while but I switched to throttlestop after having 200th problem where the undervolting gets reset on reboot, and so far I really like it.

    Now in the past I asked about using XTUon the 3rd gen and the answer is that I can't use it to undervolt and same thing for throttlestop ( http://forum.notebookreview.com/thr...able-to-undervolt-3rd-gen-mobile-cpus.837097/).

    Now my 3rd gen Intel cores are in Toughbook CF-19 Mk 6 with passive cooling and could always benefit from something equivalent to undervolting adn so can my W530 that idles at 60C and stays 90C on load.

    Can you suggest any methods to get better thermals while not sacrificing the performance using throttlestop for 3rd gen intel CPUs?
     
  2. Raidriar

    Raidriar ლ(ಠ益ಠლ)

    Reputations:
    1,708
    Messages:
    5,820
    Likes Received:
    4,311
    Trophy Points:
    431
    You cannot undervolt on 1st, 2nd, and 3rd gen intel CPUs. They do not have an integrated voltage regulator (FIVR), which means you have no control over the voltage that the chip demands. Best you can do with throttlestop is limit the power it consumes, which means it will downclock if you lower the target power rating. W530 should have a decent cooling system, you can try liquid metal in there to see if it tames the temperatures.
     
  3. SJLPHI

    SJLPHI Notebook Evangelist

    Reputations:
    12
    Messages:
    408
    Likes Received:
    59
    Trophy Points:
    41
    My W530 handles well on load okay. Never overheating but often hanging out at around 85C. They aren't out of control, I just don't like it. My CF-19 frequents 100C.