The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    raid 1 setup problems with esata

    Discussion in 'Hardware Components and Aftermarket Upgrades' started by Sir Punk, Apr 25, 2009.

  1. Sir Punk

    Sir Punk Notebook Deity

    Reputations:
    0
    Messages:
    1,061
    Likes Received:
    3
    Trophy Points:
    56
    I got this dual-bay ext enclosure from kingwin. With usb it works fine but I am having problems with the eSata port. When I plug it in the e6400 starts to stutter, I can only move the pointer every 30 seconds or so, and eventually is never recognized. I have tried both AHCI and IRRT with no luck.
    Right now I am formatting two 750GB with USB and it's taking forever.

    Can anybody help?
     
    Sir Punk, Apr 25, 2009
    #1
  2. Sir Punk

    Sir Punk Notebook Deity

    Reputations:
    0
    Messages:
    1,061
    Likes Received:
    3
    Trophy Points:
    56
    so If I run the enclosure under "normal" then the eSata works but shows only 1 disk. Intel storage manager says I have 2 ports available but I am not have port multiplier.
     
    Sir Punk, Apr 26, 2009
    #2