The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    3D Glasses not working

    Discussion in 'HP' started by texasgooner, Jan 21, 2013.

  1. texasgooner

    texasgooner Notebook Enthusiast

    Reputations:
    0
    Messages:
    33
    Likes Received:
    0
    Trophy Points:
    15
    Just reinstalled windows and drives to new mSata drive

    Using Arcsoft Theatre to watch movies, 3D glasses not working (new battery) and sometime they flicker madly, but with no 3D either.

    HP support (hahahahahaha) say there is no driver or software for these glasses, they just sense the signal from the bezel to know when to switch on.

    Everything esle on laptop fine since reinstall. Was working fine before.

    Help please.
     
    texasgooner, Jan 21, 2013
    #1
  2. sangemaru

    sangemaru Notebook Deity

    Reputations:
    758
    Messages:
    1,551
    Likes Received:
    328
    Trophy Points:
    101
    sangemaru, Jan 21, 2013
    #2
  3. texasgooner

    texasgooner Notebook Enthusiast

    Reputations:
    0
    Messages:
    33
    Likes Received:
    0
    Trophy Points:
    15
    I just put the old mSata drive in, and it works fine, I think I need to reinstall the Arcsoft media player, will try that first.

    Also notice when running 3D using this player one side of the screen was covered with a shadow. Original mSata does not do this.

    Cheers
     
    texasgooner, Jan 21, 2013
    #3
  4. AEDan1977

    AEDan1977 Notebook Consultant

    Reputations:
    98
    Messages:
    116
    Likes Received:
    1
    Trophy Points:
    31
    AEDan1977, Jan 21, 2013
    #4
  5. texasgooner

    texasgooner Notebook Enthusiast

    Reputations:
    0
    Messages:
    33
    Likes Received:
    0
    Trophy Points:
    15
    Thanks for your help, I found the problem, in Catalyst Control Center I need to set the refresh rate to 120, because Arcsoft did not set it, unlike the PowerDVD I had before.

    Regards
     
    texasgooner, Jan 21, 2013
    #5