The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Adding Bluetooth to NX9420 or NW9440

    Discussion in 'HP' started by KarlJ, Feb 16, 2008.

  1. KarlJ

    KarlJ Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Hello all,
    I'm replacing the system board in my NX9420 and I'd like to add the factory Bluetooth module. Has anyone done this here?
     
  2. schoko

    schoko Custom User Title

    Reputations:
    405
    Messages:
    1,090
    Likes Received:
    1
    Trophy Points:
    56
  3. KarlJ

    KarlJ Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Got it.... thanks! I'm just wondering if this is something I should do while the system board is out or can the cable and module be installed easily after in system board is replaced?
     
  4. schoko

    schoko Custom User Title

    Reputations:
    405
    Messages:
    1,090
    Likes Received:
    1
    Trophy Points:
    56
    dunno about the cable, but the module you can of course change without removing the whole board.

    you should check where to the cable´s connectors need to be plugged in and where the cable needs to placed, but this should also be possible without removing the whole board.
     
  5. KarlJ

    KarlJ Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Thanks! I'll use the system board swap as a recon to see what goes where....