The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    DV6-6xxx not overclocking

    Discussion in 'HP' started by iBass, Mar 12, 2013.

  1. iBass

    iBass Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    The BIOS is updated, the stock win8 driver is installed, but when I try to apply a setting in MSI afterburner, all it does is revert back to stock clocks. Any help?
     
    iBass, Mar 12, 2013
    #1
  2. Kirrr

    Kirrr Notebook Deity

    Reputations:
    253
    Messages:
    901
    Likes Received:
    39
    Trophy Points:
    41
    Use the newest Leshcat driver. You can not overclock on the stock drivers.
     
    Kirrr, Mar 13, 2013
    #2
  3. hypertek

    hypertek Notebook Consultant

    Reputations:
    9
    Messages:
    227
    Likes Received:
    21
    Trophy Points:
    31
    How do I overclock with leshcat drivers? I installed his 13.1 drivers, than go to the utif options and enable overdrive? Than opened up msi afterburner and its 0 for me.
     
    hypertek, Mar 13, 2013
    #3
  4. Kirrr

    Kirrr Notebook Deity

    Reputations:
    253
    Messages:
    901
    Likes Received:
    39
    Trophy Points:
    41
    If you enabled the overclock during driver install you can overclock the card using the catalyst control center. There should be a page that says overdrive.
     
    Kirrr, Mar 14, 2013
    #4