The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Disassembling a dvx500

    Discussion in 'HP' started by ToxicBanana, Sep 7, 2007.

  1. ToxicBanana

    ToxicBanana Notebook Consultant NBR Reviewer

    Reputations:
    19
    Messages:
    170
    Likes Received:
    0
    Trophy Points:
    30
    I want to install a bluetooth module in my dv2550se. Does anyone know if the rubber screw covers around the screen come off easily? I don't want to pry them off if they aren't going to go back on snugly.
     
    ToxicBanana, Sep 7, 2007
    #1
  2. suland

    suland Notebook Evangelist

    Reputations:
    8
    Messages:
    490
    Likes Received:
    0
    Trophy Points:
    30
    They should come out easily. Make sure you use plastick pin to take them out not to scratch the surface.
     
    suland, Sep 7, 2007
    #2