The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Raw Read error rate!

    Discussion in 'HP' started by mr__bean, Oct 5, 2008.

  1. mr__bean

    mr__bean Notebook Evangelist

    Reputations:
    36
    Messages:
    449
    Likes Received:
    0
    Trophy Points:
    30
    Ok my raw read error rate is 215824 according to HDTune, and the seek error rate always goes from 0, to 2600 and then resets to 0 and counts again? Does this mean that the harddrive is fault..? because the laptop is only a week and a bit old if that.

    Please help!

    hardrive is a Fujitsu MHZ2250BH G2.

    Just for an idea of how new the laptop is the power on time is 148 hours.
     
  2. John Ratsey

    John Ratsey Moderately inquisitive Super Moderator

    Reputations:
    7,197
    Messages:
    28,840
    Likes Received:
    2,165
    Trophy Points:
    581
    Sometimes software doesn't correctly read the SMART data.

    First try the Fujitsu diagnostic utility. That should read the SMART data correctly.

    If the diagnostic utility says the HDD is OK then download and install the ActiveSmart trial. It monitors changes to the SMART data and will tell you if there are changes.

    John
     
  3. mr__bean

    mr__bean Notebook Evangelist

    Reputations:
    36
    Messages:
    449
    Likes Received:
    0
    Trophy Points:
    30
    Thankyou :D

    Btw out of interest do you have any tips on how to speed up harddrive? id like to get the best performance out of my system :)

    x
     
  4. BBGus

    BBGus Notebook Evangelist

    Reputations:
    122
    Messages:
    404
    Likes Received:
    0
    Trophy Points:
    30
    You can't really speed up a hard drive. The only thing you can really do to get better performance is to limit how many things access the drive at a time as well as how many times you access drive. You can limit how many things access the drive by checking and making sure programs/processes running in the background are essential and not just junkware. You can limit how many times the drive is accessed by having a good amount of RAM so that the system can store it there instead of constantly seeking the hard drive.

    BBGus