The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Targus Power Tips for ZT3000

    Discussion in 'HP' started by rjharper, Nov 4, 2004.

  1. rjharper

    rjharper Newbie

    Reputations:
    0
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    5
    Does anyone use a Targus air/auto DC adapter with a ZT3000, and if so, which adapter, and which tip, do you use. I purchased the 200U which is a 120W supply (I know I only need 65W but my colleagues run DTR models), which comes with a selection of tips but none fit the ZT3000.
    The targus website says tip #44 and 2A fit the ZT series, but Targus tech support says the ZT3000 is not supported yet. I'm confused, and hope somebody else might have an answer.

    Thanks, Ross



    "There are few problems in life that cannot be solved by the suitable application of high explosives"
     
    rjharper, Nov 4, 2004
    #1
  2. wgehrke

    wgehrke Notebook Consultant

    Reputations:
    1
    Messages:
    132
    Likes Received:
    0
    Trophy Points:
    30
    Ross, I do not know if this will be of any help, but my ZV5000z uses the HP powerbrick PP017H and also says HP-OW121F13. I currently do not have a Targus unit but did operate successfully with one for about a week. If your HP unit is the same model look up the Targus adapter for the ZV5000z.

    Bill :::: zv5000z :: 3200+ :: 1GB :: 60GB 7200rpm :: 15.4" WSXGA+ (1680x1050) :: XP Pro
     
    wgehrke, Nov 7, 2004
    #2