The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Voltage control with catalyst control center

    Discussion in 'HP' started by tiner, Oct 24, 2012.

  1. tiner

    tiner Notebook Evangelist

    Reputations:
    101
    Messages:
    435
    Likes Received:
    16
    Trophy Points:
    31
    Hello everybody,

    Just wondering if I can control it with catalyst control center. I know that some catalyst releases allow this kind of voltage and oc control (I remember overclocking the card from the CCC) but the one I have at the moment does not allow me to control the voltage or overclocking (I'm on leshcat 12.9)

    Any idea about it?

    Thanks.


    PD: MOH warfighter runs incredible smooth, even with the specs on ultra.
     
    tiner, Oct 24, 2012
    #1
  2. Kirrr

    Kirrr Notebook Deity

    Reputations:
    253
    Messages:
    901
    Likes Received:
    39
    Trophy Points:
    41
    You need to install msi afterburner, than apply the overdrive enabler in the leschat drivers installer. Than there will be the overdrive option in the Catalyst.
     
    Kirrr, Oct 25, 2012
    #2