The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Lenovo ActiveProtection and 2 HDDs (T500)

    Discussion in 'Lenovo' started by lenardg, Mar 26, 2011.

  1. lenardg

    lenardg Notebook Evangelist NBR Reviewer

    Reputations:
    331
    Messages:
    513
    Likes Received:
    0
    Trophy Points:
    30
    Hi,

    Does anyone know that if I use the ThinkPad Serial ATA adapter to put another HDD in my T500, does the ActiveProtection software stop both HDDs (built in HDD, bay-adapter HDD) at the same time?

    Also, usually the advice is to remove ActiveProtection is you have a SSD disk, because they are not sensitive to movement. What about if you have an internal SSD disk and a regular HDD in the bay? Any experience with this setup using ActiveProtection?

    Thanks!
     
  2. Colonel O'Neill

    Colonel O'Neill Notebook Deity

    Reputations:
    300
    Messages:
    935
    Likes Received:
    0
    Trophy Points:
    30
    HDAPS supports the UltraBay.
     
  3. lenardg

    lenardg Notebook Evangelist NBR Reviewer

    Reputations:
    331
    Messages:
    513
    Likes Received:
    0
    Trophy Points:
    30
    Not much help from HDAPS, since I am using Windows only. As far as I know HDAPS is Linux only.
     
  4. Colonel O'Neill

    Colonel O'Neill Notebook Deity

    Reputations:
    300
    Messages:
    935
    Likes Received:
    0
    Trophy Points:
    30
    Whoops my bad. I tend to call it HDAPS in Windows too.
     
  5. MidnightSun

    MidnightSun Emodicon

    Reputations:
    6,668
    Messages:
    8,224
    Likes Received:
    231
    Trophy Points:
    231
    Yes, APS does park both the hard drive in the main bay and in the UltraBay when a shock is detected by the accelerometer on the Thinkpad mainboard. See the APS source article from Lenovo, quoted:
    I'm not too sure what the behavior of the primary SSD would be in this case, though. I assume the SSD would just ignore the parking command that it receives, so there shouldn't be any negative impact? You'd probably have to test and see.