The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Should I repaste my Lenovo y410P?

    Discussion in 'Lenovo' started by sweatyballz, Nov 24, 2014.

  1. sweatyballz

    sweatyballz Notebook Consultant

    Reputations:
    0
    Messages:
    153
    Likes Received:
    0
    Trophy Points:
    30
    I am not sure how bad the factory paste job is, but if I am having temperatures while gaming at 80 degrees c for both the GPU and CPU, do you think the laptop can last atleast four years?
     
  2. glewarne

    glewarne Notebook Guru

    Reputations:
    11
    Messages:
    50
    Likes Received:
    16
    Trophy Points:
    16
    Every single Lenovo I have ever opened has had a poor factory paste job. Usually one of two distinct varieties

    1 - Something that resembles a golf ball sized blob of good paste gooped over the entire gpu/cpu
    2 - a hard, dry "wafer" of clay like material

    The first one isn't so bad if they hadn't applied quite so much, but the second type is definitely the worst. Every "paste wafer" (as I call it) I have replaced with decent paste like AS5 or Shin-etsu ive seen temp drops over 10c at idle and load

    My current u430 touch had the "paste wafer" from factory, temps were abhorrent, 54c on idle on the ulv cpu. Replaced with shinetsu, 27-34c on idle depending on ambient temps. same with the 730m gpu.

    If you have the ability to do so, I would do it. You cant make the temps worse (if you do it properly, anyway).....